Vibration cutting function can be added

Introduction to the chip breaking function of 0I-TF PLUS on the lathe controller. At present, the controller 0I-TF PLUS launched by FANUC last year can add the Vibration cutting function. It has been tested on Fuso FCL-140/200HT FBL-230 FNL-220LY and other models The effect of chip breaking can indeed be achieved, but if the spindle speed is higher than 1800RPM, the vibration of the table will be larger, and the processing conditions need to be adjusted again (because thousands of cutting conditions higher than 2000RPM have not been tested) There is no difference in the cutting processing time when the Vibration cutting function is turned on. Surface roughness will increase slightly during finishing (slightly worse than standard finishing)